ECMS2: BGP Use Cases

SOLVED
pdeleuw
Getting noticed

ECMS2: BGP Use Cases

Hi,

I have a question about the Meraki BGP use cases in the ECMS2 course.

There is an use case "Active-Active Datacenters". The slide shows load balancing achived via AS-Path prepending. Where would the AS-Path prepending be applied? From the slide it seems it has to be applied on the Hubs. So the slide makes sense. But I do not see any option to configure it on a Meraki MX. The only BGP configuration is BGP enable/disable, AS number and the hold timer. It would be nice if someone could clarify it.


Best regards


Peter

1 ACCEPTED SOLUTION
ww
Kind of a big deal
Kind of a big deal

Its done automatically based  on the spoke primairy and secondary hub setting . The spoke subnets are send prepended when advertised at the secondary hub

View solution in original post

2 REPLIES 2
ww
Kind of a big deal
Kind of a big deal

Its done automatically based  on the spoke primairy and secondary hub setting . The spoke subnets are send prepended when advertised at the secondary hub

pdeleuw
Getting noticed

Thank you, that seems to make sense ...

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.