New articles:
Cisco C9350 Smart Switch Onboarding Guide
Change: New article.
Secure Connect:
Cisco Secure Connect Reserved IP
Change: Added "Cisco Meraki" to "Select domains from the following services".
SD-WAN & Security:
Change: Updated availability: "The feature is still visible on the Meraki Dashboard for devices configured to run earlier firmware versions, but it is based on an older, 3rd-party classification system that no longer functions as of January 1, 2025."
Switching:
Layer 2 Multicast and Troubleshooting
MS and CS Firmware Features Directory
Change: Added new live tool: Layer 2 Multicast Table.
Change: Added "**Stacking Limit for C9200L(-M): C9200L series models running Cloud Management with IOS XE 17.15+ support stacking configurations of up to 5 members. Please ensure your stacks for these models adhere to this limit. Exceeding 5 members may lead to unexpected behavior. This will be resolved in a future release."
Wireless:
Change: Added "Idle power consumption"; added "Typical power consumption"; added note about actual power consumption may vary depending on AP usage.
WPA3 Encryption and Configuration Guide
Change: Added "With MR 31.1.7, Wi-Fi 6E Access Points configured with WPA3 Transition mode will enable the 6 GHz radio."
OpenRoaming integration with Cisco Spaces
Change: Added sections "Common Deployment Scenarios", "Architecture for OpenRoaming - New!", "Pre-requisites for Configuring Meraki OpenRoaming" and "Configuration Prerequisites on Meraki Dashboard".
Hanshow Electronic Shelf Labels (ESL) Integration with MRs
Change: Updated supported USB ESL gateways: "Hanshow HS_C09978 and HS_C09979 gateways are supported with this integration."
Change: Added "If an AP receives 4 CDP entries with higher priority (determined by the lower MAC address), LLDP entries will not be stored, resulting in no LLDP information being shown on the AP. If you do not see LLDP info on the AP, configure the switch to stop forwarding CDP packets and check if this resolves the issue."
Campus Gateway Deployment Guide
Change: Added "Adding CGs to a network using the Meraki app is currently not supported."
Cameras:
Change: Added MV23, MV33, MV53 MV63, MV73, MV93 and MV84; added "MV84X can support 1 stream per imager."
General Administration:
Best Practices for Meraki Firmware
Change: Added "Firmware lock, is a temporary measure to be used mainly for testing purposes, It is not meant for long-term usage/remain on the device outside the troubleshooting session."
Change: Added "Contact Cisco Meraki support to adjust the MTU for Non-Meraki VPN and Client VPN tunnels, this requires MX19.1.11 or higher firmware."
Ways to Contact Meraki Support
Change: Added section "Submit a Case through Help Center" and "Contact Support by Chat".
