Adding and Updating Celular Firewall rules does not change srcPort or destPort.

Solved
Clifra-Jones
Conversationalist

Adding and Updating Celular Firewall rules does not change srcPort or destPort.

I am working with the V1 API function Update Network Appliance Firewall Cellular Firewall Rules.

It seems the source and destination ports do not get updated when calling this method.

 

This is my message body I am sending to the API method:

{
  "rules": [
    {
      "comment": "This is a test 3",
      "policy": "allow",
      "protocol": "any",
      "srcPort": "8080",
      "srcCidr": "192.168.129.0/24",
      "destPort": "80",
      "destCidr": "192.168.128.0/24",
      "syslogEnabled": false
    }
  ]
}

It seems I can update any other property but the srcPort and destPort. I have successfully updated the comment and subnets several times.

Check out my Meraki API PowerShell Module.
Powershell Gallary: https://www.powershellgallery.com/packages?q=Meraki-API-V1
Project Site: https://github.com/Clifra-Jones/Meraki-API-V1
1 Accepted Solution
Ryan_Miles
Meraki Employee
Meraki Employee

You're using this endpoint https://developer.cisco.com/meraki/api-v1/update-network-appliance-firewall-cellular-firewall-rules/... Just tested on my MX and it works fine for source and destination port changes.

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

View solution in original post

2 Replies 2
Ryan_Miles
Meraki Employee
Meraki Employee

You're using this endpoint https://developer.cisco.com/meraki/api-v1/update-network-appliance-firewall-cellular-firewall-rules/... Just tested on my MX and it works fine for source and destination port changes.

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

That’s what I was wondering. I am using the dev sandbox. I can’t test this functionality on my production MXs. All the other methods I’ve tested so far seem to work. 

Good to know it works. I can move on to test other methods. 

Check out my Meraki API PowerShell Module.
Powershell Gallary: https://www.powershellgallery.com/packages?q=Meraki-API-V1
Project Site: https://github.com/Clifra-Jones/Meraki-API-V1
Get notified when there are additional replies to this discussion.