Unable to see MR in network clients page

[BlakeRichardson]

I've just noticed that if i search either using the MAC or IP of an MR access point under Network-wide >Clients  nothing shows up. Is anyone else having this problem. 

I have double checked I am looking at the correct network within my dashboard and I don't have any filters enabled. 

Am I going mad or is this normal?

[RWelch · Accepted solution]

MR MAC addresses and IPs don't usually show up in the dashboard for L2 networks but do on L3 networks being based on a different client tracking method (option).

Client-Tracking Options 

Note: The following ports don't support Client Tracking features on MS390 & C9300/L/X-M.

1. Ports with supported max speeds 25G, 40G, 100G.

2. Link Aggregation ports

[BlakeRichardson]

@RWelch is this the same for MS devices as these aren't showing either. 

[RWelch]

@BlakeRichardson correct (yes).

[BlakeRichardson]

Hmmm in all of time of been using Meraki devices I have never noticed it. Thanks for clarifying it.

[cmr]

If you reboot everything, they do sometimes show up for the first few minutes until they are presumably filtered out.

[RaphaelL]

and sometimes they show up with the damn 1.1.1.1 IP 😫

[cmr]

That's the one 🙃