Meraki

tduff4785 · ‎Dec 6 2023

If we went back to the original AP it would connect right away, if not it would take 3 minutes to join the new AP. Our port authentication timer inactivity config is set to 3 minutes.

tduff4785 · ‎Dec 5 2023

We found the issue, it was related to the config on the new 9400 switch and using 802.1x authentication. We had to add auth mac-move permit to the config. This was something that was enabled by default on the 4500s but not on 9400s.

tduff4785 · ‎Nov 9 2023

We are running Cisco Meraki APs that are connected to a Catalyst 9410 switch and are experiencing and issue with roaming. We put in the 9410 switch last week replacing a 4510. We did not have this issue when the same Meraki APs were connected to the 4510 and the 9410 has the same port config that the 4510. The Meraki dashboard is just showing Bad Roams or Suboptimal Roams, no other information is given. Curious if anyone else has come across this issue or something similar in the past, if so what was the solution if there was one.

Meraki

Community

About tduff4785

tduff4785

Community Record

Re: Catalyst 9410 and Cisco Meraki Roaming

Re: Catalyst 9410 and Cisco Meraki Roaming

Catalyst 9410 and Cisco Meraki Roaming

Re: Catalyst 9410 and Cisco Meraki Roaming