Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Dave_B
Dave_B
Comes here often
Member since Nov 7, 2023
4 weeks ago
Community Record
9
Posts
0
Kudos
0
Solutions
Badges
a month ago
well I didn't do a cable test per se`...I just checked the port using cli command sh int gi0/x. port shows clean. I actually just noticed a few others showing the same alerts from several different sites. I have 5 locations around the globe.
... View more
a month ago
Hello, I have an Ap (MR46E) that has an alert of "Ethernet uplink speed degraded". I've checked the cable by investigating the port...no errors, CRCs, drops...cable seems good. I've bounced the port. I have the port set for auto/auto and the port is showing 100/full. It's firmware is fully updated. I've set the port for 1000/full, but once I set the speed to 1000, the AP drops and the port shows not connected. Port is showing power is still being issued with 30w. Not sure what is happening... This Ap has been running fine for over a year and this just started happening a week ago. Any ideas???
... View more
Feb 16 2024
9:08 AM
Thanks for the input and suggestions. I will look into all of this
... View more
Feb 16 2024
6:41 AM
Hello, I have a remote site that has a lot of users that connect their mobile phones to wifi and eventually exhaust my DHCP scope. I want to block these devices from connecting at all. I have used the block policy, however, these devices still connect and pull a DHCP IP, just have no network access. doesn't really do much good to block them if they still pull an IP. Is there a way within Meraki to completely block a device from connecting and pulling an IP address? Thanks, Dave
... View more
Nov 8 2023
7:35 AM
mandatory DHCP was enabled. I disabled it and my PLCs started pinging. Thanks for the pointing that out. I'm curious how this works...the AP is only accepting traffic from a DHCP response? If there is no DHCP response for an IP, no traffic passes over the AP?
... View more
Nov 7 2023
2:48 PM
I have no firewall ACLs in place for any ssid (except guest wifi). I have a laptop on a different vlan that has no access or pings to the PLC. I have a laptop on the same vlan & SSID as the PLC with no access or pings to the PLC but has full network access. I have internet restricted for this SSID but can access network shares, internal sites, printers, etc... So a computer on this SSID & vlan has no issues, but this ethernet-wireless bridge does
... View more
Nov 7 2023
1:13 PM
Hello All, Not a wireless expert by any means. I have an ethernet to wireless device (anybus bolt) that I have connected to an SSID. feeding off of that is an IoT device (PLC). I can see the PLC connected, its IP, its MAC, able to ping the device through the meraki dashboard...it's connected. However, I can't access this PLC over the network in any way...no ping, no trace route, can't see it as active in my management software. I can connect a laptop to the SSID and have full network access. I'm lost here and could really use some advice. Re-set up an old cisco AP running off my cisco controllers and the PLC works as it should. This must be something with meraki. The bolt is not wifi6 capable so I did turn off 802.11x for both 2.4 & 5 Ghz. Have a radio profile set to only use 2.4 Ghz. Both devices are using static IP, but I did try with DHCP and both did pull an address. any help is appreciated.
... View more
© 2024 Cisco Systems, Inc.
