Is it possible to generate a report of users connected to (and disconnected) the whole network with the AP detail and time ranges. We are trying to get a user count within some areas where Meraki APs are - so if we get this data, we can generate some valuable info about the real-estate usage ... View more

So basically my colleague set this up as a small Meraki setup for an open internet. I was checking it remotely today and noticed - Internet port is configured as manual - Given an IP and gateway is set as the ISP ADSL Router IP (LAN port of ADSL modem) - In MX, Single LAN and no routes added, LAN port of meraki MX is connected to c9300 in an access port vlan 100 - 3 Meraki APs connected to same access vlan 100 (not trunk) - DHCP is enabled in MX and AP's are getting an IP and internet from that DHCP scope All ports are giga, but setup only works and APs turn online once we keep it as 100mb (or auto under c9300 port config), i dont know the reason yet but assuming something with the MX setup only. I can also see under the c9300 port settings as half-duplex and 100mb. I need to resolve without interruption or a very minimum one.............Any help!!!           ... View more