Hi, We are looking to migrate from Cisco IOS to Meraki MS250 stack, the current configuration to our provider is an access vlan to a primary/secondary router, they have configured the interfaces as .251 and .252 with a vip of .253 on a /21 subnet.  The /21 is then redistributed into BGP   Example output from router.   interface GigabitEthernet0/0/1 description Customer LAN ip address x.x.x.x.251 255.255.248.0 ip helper-address x.x.x.x ip helper-address x.x.x.x standby 10 ip x.x.x.253 standby 10 priority 110 standby 10 preempt standby 10 track 123 decrement 30   Routers are currently connected to a cisco stack via access vlan 2 as follows: -   Example out from switch stack interface Vlan2 description *** WAN Services *** ip address x.x.x..254 255.255.255.224 ip helper-address x.x.x.x ip helper-address x.x.x.x   Then several other vlans carved up from the /21 on this stack   i.e.   interface Vlan110 description *** Wireless Data *** ip address x.x.x.30 255.255.255.224 ip helper-address x.x.x.x ip helper-address x.x.x.x ! interface Vlan120 description *** Wireless Voice *** ip address x.x.x.62 255.255.255.224 ip helper-address x.x.x.x ip helper-address x.x.x.x !   There is a route on the cisco stack 0.0.0.0 0.0.0.0 x.x.x.253   This works and all services are accessiable from other locations.   If migrating this to Meraki MS if we set a layer 3 interface as vlan 2 and add the other vlans as L3 interfaces adding the mgmt IP addresses as x.x.x.248 and .249 with a GW of .253 on vlan 2 I have a feeling that the switches will come online but we won't be able to reach vlan 110 or 120 Any thoughts would be appreciated.   ... View more