Meraki

SundarRRH · ‎Jun 27 2023

hi @TBHPTL , Thanks for the response ,,

SundarRRH · ‎Jun 27 2023

Hi Madhan, Thanks for your response ,we have spare of access points ,replaced the faulty one and raised RMA with Merakli support ,as Meraki doesn't have any RCA for the Issue .

SundarRRH · ‎Jun 21 2023

@cmr ,as suggested by you we'll spread them out across the switch ports and upgrade the firmware MS355 - 48X switch is running with 15.21.1 firmware version which is up to date

SundarRRH · ‎Jun 21 2023

Hello @cmr , Thank you for prompt reply.pls find the below response what firmware are you running? - to be clear end devices are Access Points running with firmware MR 28.7.1 Are your cameras spread across the switch or all plugged into one end (ports 1-21 for example)? all Plugged into one end i.e.. from port 1 to 21

SundarRRH · ‎Jun 20 2023

Hello Everyone, we have connected 21 number of MR57 access points in MS355-48X switch having 740 W power Budgeted & 296.1 W consumed .for every one week(approximately) the MR57 access points are disconnecting from the Switch and showing "POE Port was denied Power "error in the interface. we have recycled the port from dashboard , done jack-in jack out the cable from switch and we have tried connecting the same AP in other interface in same switch and other switch also, but no luck getting same error . After all the troubleshooting's Access point getting heated and not powering On can anyone help us with the above Issue and let us know how many APs can we connect to MS355-48X switch with power 740 W budgeted & 296.1 W consumed . Note : On an average each Access point consuming 14 W from interface in switch Thanks SundarRRH

Meraki

Community

About SundarRRH

SundarRRH

Community Record

Badges

Re: POE Port was denied Power_MR57-AP

Re: POE Port was denied Power_MR57-AP

Re: POE Port was denied Power_MR57-AP

Re: POE Port was denied Power_MR57-AP

POE Port was denied Power_MR57-AP

Re: POE Port was denied Power_MR57-AP