Meraki

NileshSDB · ‎May 1 2023

I will try concentrator mode. Just verify. Mx100 At HQ.. 192.158.xxx MX68 at HW different org I control 10.10.xxx Plug in Wan port to MX100 Lan get and set a satic ip on MX68 of 192.168.xxx Once I do that I will put in vpn concentratior mode.. set vpn router of 192.168.1.0/24? That is where my confusion lies.. Once I do that the branch MX I just configure with SC Wan and point to Hub... Is my thought correct.. I have never had to connect to MX on seperate org before so this is new to me. Appreciate your assistance.. Eventually once I can get teh Mx in MY org .. if possible and get into singel org I an remove concertator and setup as normal sd-wan connecitons.. Thaks for feedback and assistance.

NileshSDB · ‎Apr 28 2023

Here's my setup Mx100 managed by 3rd party different org. I would like to add MX to each branch so that I can setup a SD-Wan tunnel from each branch to my corp mx100. Since managed by 3rd party I am setting up a different org. I have created a new org and added the two MX to that org. I have setup the SD-Wan from the two Mx 68 to MX 68. However how to do I get the traffic to my lan? My goal is all the branched will connect to my Corp Mx68. so the SD-Wan is connected. easy enought. However do I do get the Corp Mx68 so my local Lan (MX100) so that the users can ping my local lan and get to the shares. Nilesh

Meraki

Community

About NileshSDB

NileshSDB

Community Record

Re: MX 68w behind MX100 for SD-Wan for branch MX's

MX 68w behind MX100 for SD-Wan for branch MX's