Meraki

Chris-12 · ‎Nov 1 2019

Thanks! Where do I find the performance of the inter-vlan routing on the MX? I looked at the spec sheets but nothing is listed. Thank you!

Chris-12 · ‎Oct 30 2019

I'm trying to decide if I should use my MX250 as my default gateway for multiple subnets instead of a Layer 3 switch that would subtend off of the MX. In the past I have used a Layer 3 switch as the default gateway because of it's ability to route packets fast. Can the MX route packets on the LAN interface as fast as a layer 3 switch (MS-350)? Any thoughts or opinions would be much appreciated. Thanks, CM

Chris-12 · ‎Dec 12 2018

Good morning, I have a similar question and was curious what your final configuration looked like. Did you end up taking a link directly off of the Inside interface of your firewall to your WAN MS switch? Did you create a separate mgmt vlan/network on your firewall, only for this switch? On the ACL piece, did you only allow access to the internet and block all internal networks? Is there a way to create an ACL to only allow the switch to talk to Meraki's cloud, if so do you know what those public IP's are? Thanks, Chris

Meraki

Community

About Chris-12

Chris-12

Community Record

Badges

Re: Using MX instead of Layer 3 switch as Default Gateway

Using MX instead of Layer 3 switch as Default Gateway

Re: Separate Management VLAN for Internet facing switch.