Meraki

HeddenSC2 · ‎Sep 8 2023

I have a MS120 as a lone switch in a small environment. I have created three interfaces. vlans 7, 11, and 150 were created. vlan 7 is set to not respond to dhcp requests. vlans 11 and 150 are set to relay to another dhcp server. I have confirmed that vlan 150 is pullling an IP address in from that server. The problem is that I can't reach that device eventhough it has an IP address in the vlan. Upon researching the issue, I see the following message. "This switch only supports interfaces for DHCP relay and IGMP snooping querier functionalities." Do I need to have a layer 3 switch to accommodate the routing as I see no routes in the MS120? If so, I may need to replace it with a MS225. Thank you, Tom Hedden SC2

HeddenSC2 · ‎Jan 24 2023

I have many Meraki switches and almost all of them are using vlan 1. So, needless to say, I am needing to change vlan 1 to another vlan. The catch is that I want to change the vlan and keep the subnet that was assigned to vlan 1. I am needing the process of accomplishing this task. I would appreciate any assistance with this.

Meraki

Community

About HeddenSC2

HeddenSC2

Community Record

not able to reach devices on the network.

Trying to replace vlan 1 with different vlan without changing the subnet.