The Meraki Community
Register or Sign in
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About thi4go_p
thi4go_p

thi4go_p

Just browsing

Member since Jun 5, 2018

‎06-06-2018

Community Record

4
Posts
0
Kudos
0
Solutions

Badges

1st Birthday View All
Latest Contributions by thi4go_p
  • Topics thi4go_p has Participated In
  • Latest Contributions by thi4go_p

Dot1Q trunk is possible on Passthrough Mode?

by thi4go_p in Security / SD-WAN
‎06-05-2018 09:58 PM
‎06-05-2018 09:58 PM
Hi,   I've some doubts about Meraki MX behavior while in Passthrough mode. I want to know if is possible connect the MX between a core switch and a router that have dot1q enabled (multiple vlans) in passthrough mode.   Switch (trunk) -----> Meraki MX (passthrough) -----> Router (with sub-interfaces)   I see on Cisco page inform that VLANs aren't supported, but I don't want configure it on MX, only on the end points (Switch and Router). Thanks, Thiago ... View more

Re: Meraki MR33 Bridge Mode Not Working

by thi4go_p in Wireless LAN
‎06-05-2018 09:51 PM
‎06-05-2018 09:51 PM
Hi All,   The issue was solved. I've changed to a different VLAN (11,21 instead 10,20) and worked perfectly.   Regards, Thiago ... View more

Re: Meraki MR33 Bridge Mode Not Working

by thi4go_p in Wireless LAN
‎06-05-2018 06:42 AM
‎06-05-2018 06:42 AM
Hi Adam,   Thanks for your reply. Yes, I've DHCP running on VLAN 10 (and also on VLAN 20). I've other two APs (Aironet not Meraki) connected utilizing the same configuration, and DHCP works normally, but on Meraki not.   About the port-security. Yes, the intention is limit the maximum users at the same time. I've tried without the port-security, but no luck too.   Checking on Meraki, I can see that is really occuring an issue with the DHCP.   I'll try capture the packets, as you suggested. Also, try enable the DHCP server directly on switch to see what happen.   Thanks. ... View more

Meraki MR33 Bridge Mode Not Working

by thi4go_p in Wireless LAN
‎06-05-2018 05:06 AM
‎06-05-2018 05:06 AM
Hello,   I'm facing issues for activate my meraki MR33 as bridge mode. I've followed meraki site instructions but still don't working. Client don't get any IP address.     Below is the Switch configuration. I've utilized the same config from my Aironet APs (that works very well).   Don't know if need a special config or a missing something.    Regards, ... View more
Labels:
  • Labels:
  • Installation
  • SSID
Powered by Khoros
custom.footer.
  • Community Guidelines
  • Cisco Privacy
  • Khoros Privacy
  • Privacy Settings
  • Terms of Use
© 2023 Meraki