Meraki

MicahLackey · ‎Dec 7 2022

Thanks, everyone for the replies. I found out that my access rights were not set correctly

MicahLackey · ‎Dec 1 2022

That is what I did but I get an error message and it will not save. Now this is a Lorex dvr model LH118000. that wants to use port 80 but I am changing to 8080 and it also uses 9000. I know there is an issue with using 80 and that is the reason for change

MicahLackey · ‎Dec 1 2022

I am very new to this process and could use some help!! I was following the instructions from https://documentation.meraki.com/MX/NAT_and_Port_Forwarding/Port_Forwarding_and_NAT_Rules_on_the_MX When I try to put "Any" under Allowed IP's and try to save I get an "error saving page" I have a CBS350 connected to this and have set up port 18 with a lan ip and need to know how to point this rule there Thanks

Meraki

Community

About MicahLackey

MicahLackey

Community Record

Badges

Re: Meraki 67 Port Forwarding for DVR

Re: Meraki 67 Port Forwarding for DVR

Meraki 67 Port Forwarding for DVR

Re: Meraki 67 Port Forwarding for DVR