About Gus3

Gus3 · ‎10-30-2022

WAN1 is primary, LB is disabled. I want all traffic going out WAN1 unless it's destination is 10.64.2.xxx, a single, no-changing IP destination. My rule look s like this Protocol Source Src Port Destination DST Port Preferred Uplink Any Any Any 10.64.2.xxx/32 Any WAN2 A tracert shows routing through WAN1. In addition, the destination will only accept traffic for my WAN2 IP. And my attempt to connect to the destination fails. I can assign the Static IP of the WAN2 connection to a laptop and the connect works.

Gus3 · ‎10-30-2022

This is a test environment before I try it on the customers production MX64. I have 2 Internet feeds. WAN1 is configured with one Internet provider and Port 4/WAN2 is configure with another Internet provider. I want all traffic to go out WAN1 unless it's destination is a certain IP address. I cannot seem to get this to work.

Gus3

Community Record

Re: MX64 Route specific traffic though WAN2

MX64 Route specific traffic though WAN2