Good point. Has anyone tested this and can confirm, that it doesn't work? It's not a huge deal even if I have to use a single switch for the aggregation.   ... View more

I'm not doing any routing on the switch. it's all layer 2 switching.  ... View more

Sorry didn't understand what you mean ADSL circuit is internet circuit. ADSL line with an RJ11 port connected to the Cisco ADSL router, and then Router is connected to the Meraki. What I think this connection would be in the Internet/WAN port of the Meraki and the Cisco ADSL router. However, my question is where should I do the NATing? At the moment I'm doing it in the ADSL router. ... View more

MPLS is for voice traffic only. Data traffic will be on ADSL. I'm not thinking about voice at the moment. I'm just wondering how to set up routing in the Meraki device?  I've done other site with Meraki as an edge device and connected directly to the internet with an Etherwire connection I've put the routing as following: https://imgur.com/a/wHDd3WS   But with this design, its ADSL and Meraki doesn't have RJ11 support. So I've put a Cisco 877 ADSL router as the edge device to connect to the provider. but not sure how to configure routing between the ADSL device and Meraki. Should I create another static route pointing to the ADSL router?     ... View more