About jeanIoa

jeanIoa · ‎02-14-2023

Hi thank you for you replay - I see it but only patch and sector antenna's but no dual-band omni with long coax cable to leave the AP outside of the fridge -

jeanIoa · ‎02-14-2023

Hi - thank you for the feedback it could be a good solution - I need just to check with the customer the lowest T° the fridge can go - thx again !

jeanIoa · ‎02-14-2023

Hello, I have a customer who has today old Cisco AP's but with ANT2544V4M-R (installed in a fridge) - I plan to use the MR76 but can I use this antenna on my MR76 ? there is no equivalent on the MR76 datasheet only patch and sector antenna's Any idea ? Thank you jean

jeanIoa · ‎12-14-2022

Yes Indeed but the config was empty - I didn't made a factory reset - I'm installing a lot of MX and the first time I had this problem with the 105

jeanIoa · ‎12-13-2022

Hi, I had a problem with a MX105 where I didn't get any IP address in DHCP mode. The same WAN connection is OK when I connect my PC in DHCP but not for the MX - I had to give a fixed IP address in order to reach the Cloud - quite a problem for me has I have to rool-out quiet a few MX in the coming month Any Idea ? Txs jean

jeanIoa · ‎10-04-2022

this could be also a good idea - I think that I will take this one - txs

jeanIoa · ‎10-04-2022

thank you

jeanIoa · ‎10-03-2022

Hi, I plan to use 2 X MR86 + MA-MNT-27 (2X) to make a link between 2 buildings in mesh. The question is the following: - on one of the building (very small +/- 25m2) I plan to have a local AP (MR30H) - so I will have the MR86 connected to the MR30H. There is no switch on this building - Do you think I will need this MR30H or with the MR86 I will have the link to the other building and the local coverage ?? Txs Jean

jeanIoa

Community Record

Badges

Re: MR76 & external antenna's

Re: MR76 & external antenna's

MR76 & external antenna's

MX105 DHCP problem

Re: MR86 + MA-MNT-27 - Mesh

Re: MR86 + MA-MNT-27 - Mesh

MR86 + MA-MNT-27 - Mesh