我遇到和你类似的问题，MX250，主备模式，两条城域网，电信和联通，分别插入WAN1和WAN2，静态IP，VIP虚拟IP，主上行链路设置为WAN2,负载均衡启用，在测试中，当WAN2断线时，理论上这个时候的流量应该会从WAN1出口通信，但实际上WAN2断线会导致整个网络都断网，简直反人类😂在前期测试环境中调整了各种可能的选项反复测试都是如此。 I encountered similar problems with you, MX250, active-standby mode, two metropolitan area networks, telecom and Unicom, insertED WAN1 and WAN2 respectively, static IP, VIP virtual IP, primary uplink set to WAN2, load balancing enabled, in the test, when WAN2 is disconnected, in theory, the traffic at this time should be egress communication from WAN1, but in fact WAN2 disconnection will cause the entire network to be disconnected, which is simply anti-human This is true of the various possible options that were adjusted in the pre-test environment. ... View more