Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Scott3
Scott3
Comes here often
Member since Apr 26, 2022
Oct 3 2023
Community Record
10
Posts
0
Kudos
0
Solutions
Badges
Oct 3 2023
2:22 AM
Hi I have a bridged network that will be available to all but i want to restrict availability 9-5 to specific users. So by default block users at that time unless they are allowed. Is this possible without adding a policy on every device. I was looking at restricting the bridged ssid at that time but them using a group policy to over ride the ssid availability. Is this possible.
... View more
Hi we get this working if we have external power to the repeater AP. But we would like to use the extension switch to provide POE to the AP. CAn the switch be powering the AP and use that link as the extension as doesnt seem to work.
... View more
Thanks have set up bridge ssid on AP and using meraki switch connected to repeater to extend LAN.
... View more
Sep 23 2023
2:53 AM
If I have a MR76 running as a repeater, can i change the ethernet port to local access to connect non wireless device to it. Or can i mesh a non meraki wifi device onto it.
... View more
Aug 23 2023
3:47 AM
I have a customer that wants to loadshare down two ISP links on a single mx85 to a non meraki vpn. And also have flow preference for some traffic outside of vpn. Is this possible? looks to me like either or not both.
... View more
Labels:
- Labels:
-
3rd Party VPN
Apr 26 2022
9:06 AM
Yes it seems to be advertising the mpls routes out to the spokes but only from the mx85 hub. We do not have allow transit ticket on the BGP config, and all peers to the hubs are in same AS.
... View more
Apr 26 2022
8:59 AM
Hi have case 07969187 open for this, should have access to network
... View more
Apr 26 2022
6:15 AM
HI I have a three hub network on AUTOVPN. with spokes connected to all three hubs. The hubs act as gateways to existing MPLS network. I connect all three hubs via BGP to the local mpls routers. I then set a default "internal route" that sends out to the spokes. Trouble is one of the hubs MX85 HA seems to be sending out the learnt routes from the mpls and now all traffic goes via this link as has better matches. I cannot find out any detail why this is doing it and not the others. the other hub sites are larger and mx250 devices HA. this is causing all traffic route via the smaller hub rather than the larger ones the work around i have used is to disconnect this hub from majority of the network.
... View more
Labels:
- Labels:
-
Auto VPN
© 2024 Cisco Systems, Inc.
