Thanks everyone.  I was running my PCAP from my laptop connected to one of the Z3 LAN ports. I have an application on my corporate laptop (RedSky My E911 Client) that relies on LLDP to discover the wired network it is connected to for E911 compliance.  I am seeing the Z3 connected to my home network.   3560X-UPOE_L3_Switch#sh lldp neighbors  gi0/5 Capability codes:     (R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device     (W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other   Device ID           Local Intf     Hold-time  Capability      Port ID Z3-Teleworker-12890 Gi0/5          120        R               0  Total entries displayed: 1 3560X-UPOE_L3_Switch# ... View more

I bounced the entire unit, I see my laptop broadcasting LLDP, but nothing sourced from the Z3. I am running firmware MX16.16, which shows "up to date". ... View more

rymikles,   Is this enabled by default on the Z3?  My Z3 does not show any LLDP data when running a packet capture.  I have looked at the configuration page of my Z3 and I do not see anything close to LLDP or even specific port configuration settings like I have on my MS200 ... View more

So the data in this link is inaccurate?   https://documentation.meraki.com/General_Administration/Other_Topics/LLDP_Support_on_Cisco_Meraki_Products ... View more