Meraki Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About br_BlueTie

Re: SSID and native VLAN

by in Wireless
‎Mar 14 2022 4:26 AM
‎Mar 14 2022 4:26 AM
I see. Thanks! ... View more

Re: SSID and native VLAN

by in Wireless
‎Mar 10 2022 4:26 AM
‎Mar 10 2022 4:26 AM
Okey. Thanks for clearing that up! I only have those two networks so vlan 20 is set as the management vlan under switch settings -> management vlan. So the devices have IPs in vlan 20. But I need to use native vlan on the trunk ports to the APs for them to send dhcp requests, right? And because the management vlan and the native vlan are the same I can't tag vlan 20 on the ssid. So the best would be to use vlan 20 only as management and native, and create a third network(vlan 30) that would replace vlan 20 as the internal network? Did I understand that correctly? Are there any problems leaving it as it is? ... View more

SSID and native VLAN

by in Wireless
‎Mar 10 2022 2:08 AM
‎Mar 10 2022 2:08 AM
Hi,   I've seen a couple of posts with similar problems, but I'm looking to understand the problem a bit deeper. I have MS120 switches, MR44 APs and two SSIDs (guest and internal). I would like to tag guest with vlan 10 and internal with vlan 20 but the problem is that vlan 20 is also the native vlan on the trunk port between swiches and APs, so the SSID internal won't receive IP addresses if I tag it. If I don't tag it, it works.   So the questions are: 1. Is there a way to tag vlan 20 if I only have those two vlans and vlan 20 is used as native on the network? 2. If I don't tag vlan 20 I see that wireless clients have "native" instead of the vlan number in the column "current vlan" under connected devices. Since vlan 20 is also used for wired clients and native vlan, would that mean the wireless clients can communicate with wired clients on vlan 20? That the wireless clients would still be in vlan 20 because it is the native vlan? Does the native vlan tag them then? 3. Are there any security issues or other problems by only tagging the SSID guest and not internal? 4. When I go to the summary page on either switches or APs, under "LAN IP" and click on the pencil, I can set a VLAN under DHCP. What does this do? ... View more
Labels:
© 2024 Cisco Systems, Inc.