We have an MX84.  Prior to COVID, we installed an MG-21 cell phone backup because we were not satisfied with the uptime of our fiber connection.  When we upgraded our Fiber, it has been 100% rock solid, and we decided to depricate and remove the secondary backup ISP and the MG-21.  The one time the MG-21 tripped before the Fiber upgrade, it incurred thousands of dollars of cell traffic in a single afternoon.  The safety net was neither needed nor economical to maintain with our new ISP. I disabled the WAN2 in Security & SD-WAN -> Monitor -> Appliance Status I removed the device from our inventory in Organizational -> Configure -> Inventory, then selected "unclaim"   The Primary uplink is set to WAN1 under Security & SD-WAN -> Configure -> SD-WAN and Traffic Shaping.  Load Balancing is disabled, and Multi-Uplink VPN is disabled. Everything is working as it should, but my "Network Health Score" constantly gives me a poor rating because WAN2 is down.   One other note, we are using a connection to AWS through a VPC to provide off-site backup and redundancy to our systems. How does one delete WAN2 from the Meraki system? ... View more

I was just contacted by my failover ISP (AT&T) that we had used 265.33 GB of data between Oct 11th and November 10th.  They are trying to get more detailed information for me.  Historical device data only goes back a month.  Today being December 6th, I can only see 4 days of that time frame.   To my knowledge, the failover has never tripped over and we typically have Kbs/day rather than the 265.33GB of throughput during that time.  The 1 month of historical data that I can see supports this.    I need to see data use through the MG21 Cellular Gateway further back.  How can I do this? ... View more