Here is the OSPF for WAN routers RT01-Primary for Data ********************** router ospf 1 router-id 172.16.98.42 redistribute eigrp 1 subnets redistribute bgp 64589 subnets route-map BGP-to-OSPF network 172.16.100.216 0.0.0.3 area 0 route-map BGP-to-OSPF, permit, sequence 10 Match clauses: ip address prefix-lists: vocus-sip-service Set clauses: metric 70 <<<<< higher cost for voice service Policy routing matches: 0 packets, 0 bytes route-map BGP-to-OSPF, permit, sequence 20 Match clauses: ip address prefix-lists: Prefix-in Set clauses: metric 20 <lower cost default route here RT02-Primary for Voice *************************** router ospf 1 router-id 172.16.97.42 redistribute eigrp 1 metric 160 subnets redistribute bgp 65032 subnets route-map BGP-to-OSPF network 172.16.100.224 0.0.0.3 area 0 route-map BGP-to-OSPF permit 10 match ip address prefix-list vocus-sip-service set metric 20 <<<<Lower cost for Voice route-map BGP-to-OSPF permit 20 match ip address prefix-list Prefix-in set metric 70 <<< higher cost for default traffic Normally default route via RT01, but if problem on RT01 will go thru RT02, But the default route is not advertised on the Meraki, has static going to RT01 so would cause problems if RT01 or WAN failed On a cisco router would normally increase the cost of the static route to give preference to OSPF
... View more
