Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About JarettOpp
JarettOpp
Comes here often
Member since Oct 18, 2021
Nov 14 2023
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
Oct 19 2021
7:02 AM
I don't see spikes or dips coming from the batteries or the rectifier as these are powering other equipment in the office and we haven't seen issues with anything else. I do see the inverter possibly causing issues if it's faulty. When we measure voltage at the power cord end being plugged into the Meraki power supply, we've measured right around 120-121 volts.
... View more
Oct 19 2021
6:10 AM
The offices are temperature controlled with an HVAC system. The temperature should range anywhere from 65 to 75 degrees Fahrenheit depending on the time of the year.
... View more
Oct 18 2021
2:02 PM
The switch that we replaced this past December is actually the switch that we needed to change out again. That was after changing out the inverter and power supply again. We did receive all the switches at the same time when we did the initial install.
... View more
Oct 18 2021
1:56 PM
Commercial power is connected to the rectifier which then converts the AC power to 48V DC and charges the batteries. If commercial AC power is lost, there's a backup generator to keep the batteries charged and equipment from ever going down. The inverter that only powers the switch is wired to the batteries so it should never loose power. These switches are mainly used for our internal network traffic and managing other network devices that utilize out of band management in the office. These offices don't have much for PoE powered devices. The only PoE devices that are connected are for door access readers which doesn't demand much for power. The PoE consumption at these offices are less than 20 watts out of the available 370 watts with these particular power supplies.
... View more
Oct 18 2021
8:35 AM
The first case we had started with Meraki on this issue, we replaced the inverter powering the switch and inserted a second power supply and the switch still went offline. That resulted in a switch replacement back in December of last year. The second case we had just happened a couple weeks ago where it experienced the same issues and had a replacement switch sent to us. Was more so wondering if a second power supply in all of the switches would help us out, or if it isn't necessary.
... View more
Oct 18 2021
7:57 AM
We have over 20 MS250-24P switches that have been deployed for about 2 years now for our internal network that connect our remote offices together. Each site has a 48 volt battery plant and rectifier to supply DC power to telecom equipment. The MS switches are powered with 1 PWR-MS320-640WAC power supply connected to an inverter that's powered by the rectifier. We've had several instances over the last year where all lights on the front of the switch will power off and the switch goes offline, but the lights on the back of the power supply are lit up and looks to be operating normal. If we either unplug the power cord from the power supply and plug it back in, or reseat the power supply, the switch will come back online. We've started cases with Meraki and both times they sent us replacement switches. My questions are if anyone else has seen or heard of this happening, and if it's recommended to have 2 power supplies powering these switches even though we're not even close to reaching the power limit on the switches?
... View more
Labels:
- Labels:
-
Other
© 2024 Cisco Systems, Inc.
