Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Griz
Griz
Conversationalist
Member since Apr 17, 2018
Nov 1 2023
Community Record
9
Posts
0
Kudos
0
Solutions
Badges
Feb 13 2020
8:49 AM
Since the error is intermittent, you might try this page: https://documentation.meraki.com/zGeneral_Administration/Tools_and_Troubleshooting/Active_Directory_Issue_Resolution_Guide and check the section "WMI Error".
... View more
Sep 27 2019
8:12 AM
Just chiming in to say "me too". Something obviously changed in the last few months, and not for the better. Does anybody know of a situation where it is preferable for a cryptic MDNS name to take precedence over NETBIOS name in the dashboard? There has to be a way to identify what has changed and reverse it, right?
... View more
Aug 24 2018
11:48 AM
Thanks for the responses. I was afraid what I was asking for wasn't currently doable, and I guess it's not.
... View more
Aug 22 2018
6:42 AM
I have a site with a 10-mb fiber Internet/VPN uplink, and kept the old Uverse uplink for a backup uplink (not using for load-balancing). I would like to allow users at that site to continue streaming music (distant, rural location), but only over the backup Uverse uplink, so as to not bog down the primary uplink. Does anybody know how I can direct all streaming media requests over that uplink? The Flow Preferences option on the Traffic Shaping page of the MX only accepts specific IP's and ports as criteria. Thanks.
... View more
Apr 20 2018
9:27 AM
Sorry, haven't been able to check back in on my own topic for a couple of days. Thanks for the ideas. ScottWinCO, I think I see where you're going; in your scenario, when you say having DHCP running at HQ, do you mean just having the MX there run it and only serving up an address on the dedicated PTP VLAN, to be assigned to WAN2 on the other end? Would a warm-spare failover need any special considerations, do you think?
... View more
Apr 17 2018
1:30 PM
I did mention that I do have a cellular modem attached, but that it's quite a bit slower, and apparently not reliable. (this location is in a very rural area with very limited options). Are you saying it IS possible somehow? I'd be interested in hearing how--might be worth it!
... View more
Apr 17 2018
12:03 PM
NSGuru, The p2p uses one of the LAN ports (wouldn't want to NAT that traffic). I'm afraid you're right about the WAN interfaces, but was hoping for different, like maybe a way to set a "conditional" default route.
... View more
Apr 17 2018
9:36 AM
Hi. I have a remote site connected to HQ over a dedicated point-to-point circuit using MX84 on both ends, and that site also has its own Internet circuit on WAN1. I'm using AutoVPN on that circuit for failover in case the P-2-P goes down, and that works fine. What I'd like to know is: is there any way to configure that MX so that if the Internet circuit goes down, Internet traffic is routed to HQ over the P-2-P so that it can go out the HQ Internet connection? I have a cellular modem on the remote MX for Internet failover, but not only is it slower and more expensive, it failed to work over the weekend when the primary Internet went down until the MX was manually rebooted. Thanks for any thoughts.
... View more
© 2024 Cisco Systems, Inc.
