cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About Weaver

Re: Warm Spare one ISP/30 config using switch stack as breakout switch

by in Security / SD-WAN
‎05-05-2022 09:34 AM
‎05-05-2022 09:34 AM
Thanks for the confirmation of that. ... View more

Re: Warm Spare one ISP/30 config using switch stack as breakout switch

by in Security / SD-WAN
‎05-05-2022 08:33 AM
‎05-05-2022 08:33 AM
I'm not sure I understand your reply. ... View more

Warm Spare one ISP/30 config using switch stack as breakout switch

by in Security / SD-WAN
‎05-05-2022 07:52 AM
‎05-05-2022 07:52 AM
Hello, We are bringing a second MX84 online as a warm spare, the problem is that our ISP gives us one /30 address and we do not want to use a breakout switch in front of the MX84's but do it in the switch stack.   So, I created a new vlan 666, brought the ISP into port one of switch 1 with VLAN 666, then also included port 2 and 3 in switch one for VLAN 666 to wire into WAN 1 of each MX, essentially creating a hub to split the ISP. I'm unsure when creating the vlan if I should use "same or unique" setting in the subnetting. If I use same I need to enter the MX IP, is that the primary MX IP?   Thanks in advance for any help.       ... View more

Meraki MX 450 add a second data center redundancy design question

by in Security / SD-WAN
‎09-29-2021 11:36 AM
1 Kudo
‎09-29-2021 11:36 AM
1 Kudo
I am adding a second data center for redundancy and a new pair of Meraki MX450's. Data Center 1 has two MX 450's and will be adding 2 new 450's to the new data center. The first ones run our wireless networks for 5 different campuses. The new MX450 will be available in the event we have an outage.   I have read the design guide but I'm not 100% certain of the following question and don't want to cause an outage so...   The current MX units are running in passthrough mode. So,   1. When adding the new MX's do I create an additional network in the same organization?    The current MX units are in combined network mode.   2. How do I specify what MX units to use, the new ones or the old ones how is that priority set?   3. Do the MX units in different data centers need a heartbeat to each other even though they are on different IP networks? 4. How do they talk to each other and not take over the traffic?   Thanks for any design help   ... View more
© 2023 Meraki