Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About nflnetwork29
Community Record
11
Posts
3
Kudos
0
Solutions
Badges
Jan 7 2023
11:13 AM
2 Kudos
this did the trick. much appreciated everyone who provided feedback!
... View more
Jan 6 2023
8:50 AM
hello i am trying connect 1 single mode fiber to the Meraki port 25 using 1GB SFP transceiver single mode. LC connector . I cannot get any link light on the Meraki switch. We have tested the line to patch panel and all seems ok . is there any trick on meraki side to get this going ? there is a lack of any commands to assist with any transceiver troubleshooting that i am aware of? Switch is MS120-24P Transceiver is Cisco Meraki MA-SFP-1GB-LX10 Compatible 1000BASE-LX/LH SFP 1310nm 10km DOM Duplex LC MMF/SMF Transceiver Module https://www.fs.com/products/39371.html Patch cable is 1m (3ft) LC UPC to LC UPC Duplex OS2 Single Mode PVC (OFNR) 2.0mm Fiber Optic Patch Cable https://www.fs.com/products/40191.html
... View more
Jan 5 2023
2:09 PM
1 Kudo
got it working i was using the dedicated port on the back . once i started using one of the switchports on the front it worked.
... View more
Jan 5 2023
12:35 PM
found this (but also not working ) MS - 1.1.1.100 In order to access this address, configure a device with the following IP settings, and then browse the address in a web browser. IP address: 1.1.1.99 Subnet mask: 255.255.255.0 Note: Select MS switches have a dedicated management port that can be used without needing to set a static IP on your client.
... View more
Jan 5 2023
11:55 AM
does the mgmt port have dhcp enabled? my nic is getting a 169.x.x.
... View more
Jan 5 2023
11:27 AM
i access the local status page for the ms120-24P ? dedicated mgmt port on the back doesnt do anything . what am i doing wrong?
... View more
Nov 28 2022
8:42 AM
Hello, is it possible to plug my switch (Meraki Ms1240-24p) into a C-13 outlet? The only power cable i see is the NEMA 5-15p to > C15 MA-PWR-CORD-US
... View more
Mar 11 2021
8:41 AM
We are using 802.1X with custom RADIUS the network connectivity is good i tested all of that i added MY Meraki MR's as RADIUS clients, I set the shared secret. my testing shows the following error in the windows logs Authentication failed due to an EAP session timeout; the EAP session with the access client
... View more
Feb 1 2019
10:09 AM
been on hold 30+ mins for support what a joke
... View more
Feb 1 2019
9:51 AM
i dont even know where to begin troubleshooting this issue any help is appreciated. i have triple checked the serial # and it is correct .
... View more
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 5141 | |
| 1 | 2522 |
© 2024 Cisco Systems, Inc.
