Meraki Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About juay0004

Re: Client List not showing certain connected client

by in Security & SD-WAN
‎Mar 30 2022 6:24 PM
2 Kudos
‎Mar 30 2022 6:24 PM
2 Kudos
Hi MarcP and CMR,   Thanks for sharing your experience. These will mean that our experience are relatively consistent then. I have stream encoders which is suppose does nothing after any necessary handshake during boot up until I start stream video. Those do not appear for the longest time until i start pushing my video stream and in my observations so half, can be like half hr or so. ... View more

Client List not showing certain connected client

by in Security & SD-WAN
‎Mar 29 2022 7:48 PM
‎Mar 29 2022 7:48 PM
Hi guys,   I have issue seeing some of my wired connection clients on the client list in the dashboard. They are all receiving DHCP address from my MX67W and has connectivity to internet. is there some threshold of bandwidth usage for it to appear?   I am suspecting that low uplink bandwidth utilisation devices are not shown but cannot be sure Reason why I am saying that is one of item that did not appear was a Raspberry Pi used to show a feed of an IP camera on my LAN but it does have access to internet and is using a browser to show a World clock.. This took a very long time to appear on the list. ... View more

Re: Client not using WAN2

by in Security & SD-WAN
‎May 25 2021 6:09 PM
‎May 25 2021 6:09 PM
Hi Inderdeep,   The config for WAN 1 and WAN 2 on my end is well and established. Static IPs and both are Active as per your link. In fact I have done test for failovers and had no issue to have traffic via WAN2 when WAN 1 is disconnected.   I am facing issue in getting a particular device to use WAN2 by default after the steps I have listed. Not sure if I have missed something that you wish to point out or you have misunderstood my issue but hope this makes it clearer.   Thank you ... View more

Client not using WAN2

by in Security & SD-WAN
‎May 24 2021 7:42 PM
‎May 24 2021 7:42 PM
Hi all,   I am trying to get a device to work solely on WAN2 on my MX67W.   Here are the steps i have done: ->reserved internal IP ->set this reserved IP flow preference on WAN2 ->map a static Public IP(within my IP range) to the above reserved IP on a 1:1 NAT with all ports allocated. ->reboot the appliance under the appliance status/tools.   However, when I go on ip4.me it still shows my WAN 1 IP.   Am i missing something? ... View more
© 2024 Cisco Systems, Inc.