Meraki

AdamB1 · ‎Jun 4 2021

Actually it’s two, and both have the same issue.

AdamB1 · ‎Jun 4 2021

Already tried that, didn't help though. EDIT: And the channel utilization look good.

AdamB1 · ‎Jun 4 2021

The AP is connected to a PoE+ switch with a 1m cable. The AP's power is around 12W. The AP is connected with a gigabit cable. The AP is using both. My computer was connected on 5 GHz during the Wi-Fi test.

AdamB1 · ‎Jun 3 2021

Hi, I get 60–80 Mbit/s when connected via Wi-Fi. My computer is the only client connected to the AP. However, when I plug in the ethernet cable directly into my computer I get around 800 Mbit/s. Does the orange light (see photo) have anything to do with it, or is it something else? (The green light is flashing, the orange light is solid). Best regards, Adam

AdamB1 · ‎May 28 2021

Hi, I know I can tag APs and select groups of tags I want an SSID to be broadcasted on. However, I would like to do the opposite, i.e. select an AP and then choose what SSIDs I want to be broadcasted on that AP. Is that possible? Best regards, Adam

AdamB1 · ‎May 20 2021

Hi, I'd like to kick multiple clients off an SSID. I know I can block them permanently under Network-wide > Clients, but I'd like to just kick them out so that they can connect again if they want to.

Meraki

Community

About AdamB1

AdamB1

Community Record

Badges

Re: MR55 low throughput

Re: MR55 low throughput

Re: MR55 low throughput

MR55 low throughput

Set specific SSIDs on specific APs

Kick clients off an SSID

Re: MR55 low throughput