Meraki

Community

About Indetech

Re: Non contiguous wan IP traffic coming off a bridge

by in Security & SD-WAN
‎Apr 20 2021 6:50 AM
1 Kudo
‎Apr 20 2021 6:50 AM
1 Kudo
You are absolutely correct. the additional IP's are routing through the WAN interface even though they are a separate subnet from my WAN configuration.  ... View more

Re: Non contiguous wan IP traffic coming off a bridge

by in Security & SD-WAN
‎Apr 20 2021 5:35 AM
‎Apr 20 2021 5:35 AM
After a good bit of reading, I was beginning to ask myself that question. Thank you for the feedback. I will get that tested this morning. Thank you ... View more

Re: Non contiguous wan IP traffic coming off a bridge

by in Security & SD-WAN
‎Apr 19 2021 3:44 PM
‎Apr 19 2021 3:44 PM
Just for my own information what is the functionality of adding a second WAN port? Or is the only use of that for creating a failover service, or site-to-site branch VPN through a separate circuit?   ... View more

Re: Non contiguous wan IP traffic coming off a bridge

by in Security & SD-WAN
‎Apr 19 2021 3:20 PM
‎Apr 19 2021 3:20 PM
I can do it that way. The block I was given is a larger block and would give me the total number of addresses I need. So other than needing to get a bunch of vendors reconfigured on the new subnet. I was hoping to not have to do that. this is a pretty critical network and shuffling around a bunch of endpoint addresses is considerable work and would need to be in the wee hours crap. Thank you for the response it was worth asking before just taking the more difficult route.   ... View more

Non contiguous wan IP traffic coming off a bridge

by in Security & SD-WAN
‎Apr 19 2021 3:01 PM
‎Apr 19 2021 3:01 PM
I have an MX64 on the local side of a carrier bridge. We originally had a public subnet with 5 usable PUBLIC addresses. over time we outgrew and needed to get more addresses from our provider. They have supplied me with a new set of IPs in addition to the 5 we originally have. They have provided me an additional set that ultimately is in a separate block (subnet) than what is provisioned when I put the MX in. So I have 2 subnets coming off the bridge into the MX64. How do I configure this on the Meraki WAN side of the configuration? Do I have to add another WAN port to understand the traffic coming in on these new addresses? ... View more
© 2025 Cisco Systems, Inc.