Community Record
3
Posts
0
Kudos
0
Solutions
Badges
Bruce, Thanks for your help, unchecking "Default Route" on the hubs cleared this issue.
... View more
Bruce, Thanks for your answer. That is a possible solution we have in mind, but putting VLAN 3 in the tunnel means that all de communication to Meraki Cloud from the MR36 instead of using the MX68 Internet will use the MX250 (VPN Concentrator) Internet access. Till now we have 10 remote locations with MR36 and more coming soon. In VLAN 3 is it possible to make all traffic to use local Internet and only Radius service through VPN? Thanks!
... View more
Hi all, I have two MR36, one as mesh and the other one as gateway connected to an MX68 in routed mode. MX250 is in VPN Concentrator mode. Vlan 1 is defined as in VPN, Vlan 2 is for local breakout and Vlan 3 is for management (Native Vlan in trunk interfaces) Initially with this settings, from Access Point couldn´t reach my Radius server. After setting Wireless Alternate Management Interface in Vlan 1 for Radius, clients under MR36 in Gateway mode reached my Radius server, but clients under MR36 in repeater mode didn´t. Doing some packet capture, communication to my Radius from gateway is done by the Alt mgmt int in vlan 1 but repater uses Gateway lan IP (Vlan 3) to reach the my Radius instead of Vlan 1. Is possible to configure Mesh MR36 to use Vlan 1 for Radius as gateway does? Also, is possible to make MX68 to route all traffic, like WLC in central mode does? Thanks in advance!
... View more
