Meraki

Kasking · ‎Jan 14 2022

Hi Mooselink. Im now running MX 15.44 on my MX68 and still seeing inconsistencies with the device connection reported by the dashboard.

Kasking · ‎Dec 3 2020

@cmr, I see. Thank you for this info. I would very much like to see these changes, it would be very helpful to be able to control the port configs in the MX just as the MS, and of course, to see the correct connected ports. I'll look forward to this update.

Kasking · ‎Dec 3 2020

Thanks for your help. When I select only switch clients the list is changed to a shorter list of most of my clients (21 of them), and they are all showing connected to my 8 port switch. Its as if my MS220 is not switching, but acting like a repeater, therefore showing all the MACs from the MX as local. does this make sense?

Kasking · ‎Dec 2 2020

I probably need to be on BETA software for that. My only options are MAC and IP Address. I have no non-Meraki devices in my network right now. And they are all on the same subnet.

Kasking · ‎Dec 2 2020

Using an MX68 GE connected to an MS220-8P in my lab. Two APs, an MR42 connected to the MX68 and an MR32 connected to the MS220. The problem I've noticed for a while is that in my client list, nearly all the wired hosts report that they are connected to the MS220 when in reality most are connected to the MX68 switch ports. Upon close inspection they all seem to be connected to port 8 on the MS220 which happens to be the Interswitch Link between the MX68 and MS220. So, I'm assuming I have some kind of bridging or STP issue. Is there something I should check in the bridging configuration? I've not changed much from the defaults. thank you

Meraki

Community

About Kasking

Kasking

Community Record

Badges

Re: Clients not reporting correct connected device/port?

Re: Clients not reporting correct connected device/port?

Re: Clients not reporting correct connected device/port?

Re: Clients not reporting correct connected device/port?

Clients not reporting correct connected device/port?