Meraki Community

DBCK · ‎Feb 9 2022

We usually route our management subnet at a loopback from the MX appliance to gain mgmt to LAN kit, the kit being catalyst switches, not Meraki ms series useually

DBCK · ‎Feb 8 2022

Hi, Is it possible on an MS210-24P to configure a loopback address, I have searched but am unable to see anything so i'm either blind or it's not possible? Thanks

DBCK · ‎Jun 3 2021

Thanks for your response. How can i find out why the dashboard offered me to upgrade to MS 12.33? Not really experienced any problems so should i really need to downgrade to the stable release if i haven't experienced any problems? It just seems strange we have so many varients of releases and theres no structure to it? unless anybody can explain how there firmware versions work.

DBCK · ‎Jun 3 2021

Hello, recently we upgraded our switches to MS 12.33 firmware as it was recommended (i believe) on the dashboard. But we have since had a message appear on the dashboard advising a firmware upgrade is due however this appears to be downgrading to MS 12.28.1. I had a quick google to try find the release notes and identify is theres an issue/bug known in MS 12.33 which is why the recommended is to downgrade it, can anyone confirm if this is the case of pin point the release notes for me. Thanks, DB

DBCK · ‎May 13 2021

Thanks Philip, the problem i had with that is Meraki limits the duration to 1200 seconds (20minutes) or 100,000 packets and even filtering on UDP it runs for around 25 seconds and ive hit the 100,000 packets allready which is why i needed a more specific expression for the range i was looking at.

DBCK · ‎May 12 2021

Thanks Karstenl, something so simple but works as it should thanks for your response

DBCK · ‎May 12 2021

Hi all, i'm sure there was a filter expression with the Meraki packet captures to capture a range of ports, can anybody confirm the expression required to capture a range, for example lets say i want to capture only Microsoft teams audio i would want to filter on this port range, 50,000-50,019 expression, "port range 50000 to 50019" is what i would logically assume but is not correct, can anyone advise. Thanks

Meraki Community

About DBCK

DBCK

Community Record

Badges

Re: Can you configure a loopback on MS210-24P

Can you configure a loopback on MS210-24P

Re: Switch firmware (MS12.33 & MS12.28.1)

Switch firmware (MS12.33 & MS12.28.1)

Re: Packet captures on port ranges

Re: Packet captures on port ranges

Packet captures on port ranges

Re: Packet captures on port ranges