Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About buschtrommelXXL
buschtrommelXXL
Just browsing
Member since Oct 15, 2020
Oct 20 2020
Community Record
6
Posts
0
Kudos
0
Solutions
Badges
Oct 19 2020
11:59 PM
Hi Bruce, thanks a lot. That was it. Now it works! Can i ask you another Question? When i have only meraki switches. Is it advisable to set the STP Guards between the Switch to Switch ports? Thanks in advance! Sascha
... View more
Oct 19 2020
2:17 AM
Hi Bruce, thanks for the info. I will try it. Is it better to create a new VLAN for it with no devices in there or can i use an existing. Thanks in advance!
... View more
Oct 19 2020
12:31 AM
Hi Claes, i´ve tryed it last weekend and the network goes down again. Do i have to enable all VLANs or can i define only the VLAN´s i need. And at the moment i have configured the Ports on the MX with "Drop untagged Traffic". Can that be the reason?
... View more
Oct 16 2020
12:10 AM
Ok thanks a lot i will give it a try BR Sascha
... View more
Oct 15 2020
11:43 PM
Thanks for the info. I know that. But I've searched a lot on this subject because i wanted to find out what option of stp is the right and than i found some topics in there are spoke that stp should be disbled. Ok than that´s clear. Can you give me a tip what option of stp is right? "Root Guard" or "Loop Guard" Thanks in advance!
... View more
Oct 15 2020
11:15 PM
How can i connect the MX250 HA to a MS425 Stack. I want to connect "Fully Redundant (Switch Stack)" from each MS to each MX like in the documentations from Meraki. But how should be the configuration of the Ports. Because when i do that i get a loop and the whole network goes down. To my configuration. We have two buldings. In every building is a MX, they are in HA. In every building is a MS configured and they connected together in a Stack. At the moment it is connected as follows: MX1 Port 26 -> MS1 Port 32 MX2 Port 26 -> MS2 Port 32 The Ports of the MX are configured as a Trunk with the VLAN´s i need and Dropped Untagged Traffic. The Port on the MS are configured as a Trunk with the same VLAN´s and with STP deactivated. When i now connect additional the Ports (with the same Port configuration) MX1 Port 25 -> MS2 Port 31 MX2 Port 25 -> MS1 Port 31 The network goes down. I hope this is understandable because my english is not the best 🙂
... View more
© 2024 Cisco Systems, Inc.
