I am with @CptnCrnch - being able to meet some of the folks on this thread at CiscoLive was incredible. ... View more

Couple good links here - TheRoutingTable and TechFieldDay:   https://www.theroutingtable.com/microsegmentation-with-meraki-adaptive-policies/   For TechFieldDay - you can jump to Alex Burger's section - at approximately 36 Minutes in:   https://techfieldday.com/video/meraki-health-and-adaptive-policy/   Hope that this is helpful. ... View more

https://documentation.meraki.com/zGeneral_Administration/Tools_and_Troubleshooting/Using_the_Cisco_Meraki_Device_Local_Status_Page ... View more

Good link for reference:   https://documentation.meraki.com/MR/Radio_Settings/MR_Wireless_Regulatory_Domains   ... View more

I would be interested in testing this out !! ... View more

Unfortunately I don't have any lab gear to test this specific case out.   That would have made this process much easier.   🙂   I appreciate the response.   I have a call into my local Meraki AM and their SE to see if I can get verification.   I will post here when I receive that response.     ... View more

Thanks to both of you for discussing this.    I am more interested in doing a LAG (with LACP) using mGbe (multi-rate gigabit ethernet) interfaces.   Example:   Copper Ethernet (mGbe at 10Gbps) x 2 = 10Gbps LAG   I am assuming that both interfaces would need to be of the same type (which would be copper) and that the rate would need to be set (1G, 2.5G, 5G, 10G).      Just want to make sure that these TYPES of interfaces are able to for a LAG based on those basic requirements in the Meraki code. ... View more