cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About jbwofford

Re: Meraki not able to pull an IP from InfoBlox server

by in Switching
‎01-19-2018 05:01 AM
‎01-19-2018 05:01 AM
Thanks for the response. After some troubleshooting and being able to pull an IP intermittently we determine that our SVI only had a single DHCP helper address and the Infoblox grid would fail because it was set to have failover on the server. Basically if only one server was visible it worked. If both were on line it would give an error.    Meraki did not appear to require any thing special as far as options go. It was configuration on the router that was causing the problem. ... View more

Meraki not able to pull an IP from InfoBlox server

by in Switching
‎01-18-2018 08:47 AM
‎01-18-2018 08:47 AM
I am configuring a MS-425 and trying to get it to pull DHCP from infoblox.    Management is set to VLAN 911, port is set to 911. Have tried it as trunk and access port both.   When uplink is in place and another port is in vlan 911 a laptop can pull an IP from the scope correctly. Is there a DHCP option that the Meraki is looking for on the scope that it is not seeing? ... View more
© 2023 Meraki