Meraki

Mark-SPS · ‎Sep 10 2021

Thanks to all that replied. You've confirmed what I was expecting regarding the slower speeds. I'll look into the MS1208LP.

Mark-SPS · ‎Sep 9 2021

I'm trying to connect some devices to our MS-425 unit via a copper SFP. Devices running at 1GB connect without issue, but when trying to connect an older device that only runs at 100mb it does not connect. Same of course with 10mb. I've purchased different copper modules according to the suppliers recommendations, but the replacements act the same. Will the 425's slow down to 100mb or am I missing something? Thanks Mark

Mark-SPS · ‎Mar 15 2021

Thanks for the feedback. Yes you are correct.. I'm using W10. Also WPA2 and windows NPS for authentication. I agree that setting up authentication using the computer account and then user account is best plan and will work on setting that up. After some further testing today I see that no matter how you connect to wireless(pre or post login) it tries a computer account first and then the user account/password you enter.

Mark-SPS · ‎Mar 11 2021

Got a bit of a strange issue going on. I'm seeing 802.1X EAP failure with an identity of host/then the full pc name During the time this event occurs the pc is actually connected to the wireless network. It is connected with the normal user credentials. Same MAC address for both the connected and failing events. Same SSID as well. Anyone seen this? Thanks

Mark-SPS · ‎Sep 21 2020

Hi Philip, Thanks for the response. In looking at the RF Spectrum page I see a lot in the Interfering AP's section. I assume any/all of these could be the problem. Is there any way to tune for things like this? Or is it more of a live with it or move it thing. Thanks again Mark

Mark-SPS · ‎Sep 21 2020

I've noticed a strange issue mainly with our Outdoor MR74 AP's. Looking at the channel utilization live data shows high usage on the 2.4 Ghz channel, but there are no clients connected to the AP. Any help would be appreciated. Thanks Mark

Mark-SPS · ‎Apr 5 2020

Thanks Glden Joe. Got that nugget of info from something else I was reading but wanted to confirm before making any changes.

Mark-SPS · ‎Apr 5 2020

Hello, We have a number of MR42E units with bendable antenna's. Is there a best practice as to how these should be aimed(pointed)? These units are all mounted on ceilings facing down. Thanks Mark

Meraki

Community

About Mark-SPS

Mark-SPS

Community Record

Badges

Re: MS-425 Copper speed

MS-425 Copper speed

Re: 802.1X EAP failure while connected

802.1X EAP failure while connected

Re: Channel Usage but No Clients

Channel Usage but No Clients

Re: MR42E Aiming antenna's

MR42E Aiming antenna's