cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About TyMunn

Re: Meraki Reporting via API for WAN 2 Status

by in Security / SD-WAN
‎03-26-2020 05:29 PM
1 Kudo
‎03-26-2020 05:29 PM
1 Kudo
Nice!!! Thank's again. Exactly what we were looking for! @CCIE-Adam  ... View more

Re: Meraki Reporting via API for WAN 2 Status

by in Security / SD-WAN
‎03-26-2020 05:23 PM
‎03-26-2020 05:23 PM
Thanks appreciate it! I did find the document now and I'm going to test it in Postman. ... View more

Re: Meraki Reporting via API for WAN 2 Status

by in Security / SD-WAN
‎03-26-2020 05:10 PM
‎03-26-2020 05:10 PM
@CCIE-Adam can you point me to document or url for the uplink status endpoint you referenced previously?   ... View more

Re: Meraki Reporting via API for WAN 2 Status

by in Security / SD-WAN
‎03-26-2020 04:44 PM
‎03-26-2020 04:44 PM
We are using MX64 and MX67 devices @CCIE-Adam  I'll definitely take a look at this option as well. Thanks for your response really appreciate it! ... View more

Re: Meraki Reporting via API for WAN 2 Status

by in Security / SD-WAN
‎03-26-2020 04:43 PM
1 Kudo
‎03-26-2020 04:43 PM
1 Kudo
@BrechtSchamp this works very well thanks! Looking for something a little more cleaner you're right at least with latency I found some WAN2's that were on the console that showed ready but when I did a test failover WAN2 did not connect at all. We repositioned the 4G PepWave and then re-ran the report better signal and the failover test worked. Thank you! ... View more

Meraki Reporting via API for WAN 2 Status

by in Security / SD-WAN
‎03-26-2020 12:13 AM
‎03-26-2020 12:13 AM
I'm using the Meraki API's from a Google Sheet to get additional metrics. However, I can't seem to find and/or if a report exists for WAN2? I am using the API report under "Org Wide" then "Device Uplink Details" It gives me the status of WAN1 whether active or not or if an ip address is not defined.   Does this report or data exist somewhere for WAN2? The business use case is WAN2 is often our 4G failover and/or a slower connection alternate vendor to WAN1 but want to make sure the back is operable. ... View more
© 2022 Meraki