Purchased umbrella security. Received code via email and clicked on "claim subscription". Opens app on PC, enter password, goes to my network.   Then nothing.   No security link is available off main settings page.     Security page on GX50 does not load and crashes the app.   What is going on? ... View more

Hey   I have a MX68 (no built in cellular)  new install with two Netgear switches each on a different lan.  Voice on one switch and data on the other.  I have fibre link coming into WAN 1 and is primary.  WAN 2 is a cellular router and is set to failover from WAN1.     Data LAN (switch V1 ) carries the data for all users and connects to port 3 on the MX   Voice LAN (switch v2) carries the VOIP for all phones and connects to port 4 on the MX.   What I would like to do is if there is a failover to only allow data from V2 out WAN 2 until WAN 1 comes back on.     Is this accomplished by putting a firewall a rule in the firewall that block all traffic from port 3 going to port 2?   Will this have any adverse affects ?   would it look like this:    Policy           Protocol                    Source                     Src port              Destination                         Dst port Comment DENY              ANY.                       192.168.11.0/24       3                       0.0.0.0/24                             2      Do I need to add anything to the route table?   THanks  ... View more