Meraki

Hudson_J · ‎Feb 3 2020

Thank you guys for the input. I've found it by following your thoughts. It's about the routes and mis-configuration of Exit Hub. Thank you all.

Hudson_J · ‎Jan 30 2020

No static route at this point, hosts are directly attached to MX.

Hudson_J · ‎Jan 30 2020

Thanks for the reply, Philip. The thing is we need a full mesh topology and all sites have their own Internet resource. So there is no spoke site. And at each site I see more then one default routes. One points to WAN uplink (Internet), others point to remote VPN sites. But I don't know how to remove the unnecessary ones. And Site-to-Site outbound firewall has one default policy allowing everything.

Hudson_J · ‎Jan 30 2020

Hi Guys, Maybe I didn't get the right configuration but after I setup a site to site tunnel between two MX over Internet, hosts sitting behind these two MX can't access Internet any more. I can see remote site routes on both ends, and hosts can talk to each other. Just not sure where to configure to resume Internet access. Thanks.

Meraki

Community

About Hudson_J

Hudson_J

Community Record

Badges

Re: Loss Internet after Site to Site VPN is up

Re: Loss Internet after Site to Site VPN is up

Re: Loss Internet after Site to Site VPN is up

Loss Internet after Site to Site VPN is up

Re: Loss Internet after Site to Site VPN is up