Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About jlopez_sv81
Community Record
12
Posts
1
Kudos
0
Solutions
Badges
Oct 10 2024
8:28 AM
Yes, I have changed the password in Network-wide > Configure > General > Device configuration. So, someone else will move the device and change the configuration (uplink) using the local page and my question is if they should use the password set or Serial number to login, since the MX will be disconnected from the cloud.
... View more
Oct 10 2024
5:35 AM
Hello, I have to move a MX to a different location and the public address will be different. I have set Local Credentials for Network-wide, and I am wondering if the device loses connection to the cloud, will it keep the password saved through the Dashboard in memory? Thanks,
... View more
May 11 2023
8:42 AM
This solution is not working. Can be the issue caused by vMX and MX100 (same organization) having just 1 peer configured to MX84. There is no way to have VPN peers configured differently in MX in the same organization, the configuration is replicated to all of them.
... View more
May 11 2023
8:04 AM
Hello Gleen, That was my first option, but for some reason, the non-Meraki VPN won't connect. I have a ticket opened with Meraki.
... View more
May 11 2023
6:47 AM
Hello, Does someone know if the configuration on the diagram is possible? I am looking connection between Azure networks (vMX) and the networks behind MX84.
... View more
Mar 11 2021
6:44 AM
but, is the configuration still available after removing of network the damaged switch?
... View more
Mar 11 2021
5:32 AM
Hello everybody. I have to replace a Switch with a fan fail and I would like to know more about the replacement process. Are these the steps to follow? Remove the damaged device and unclaim. Add new device and claim. Clone de new device. Can I clone a new switch using the previously removed switch configuration? Is the configuration still available? Thank you.
... View more
Feb 11 2021
6:15 AM
Sound like a route-map not supported by Meraki, but is a straightforward network, a switch with L3 Vlans point default route to MX.
... View more
Feb 10 2021
12:34 PM
I have NAT 1:1 configured on MX100 for an internal server using the secondary link, Inbound traffic work fine but when I make a traceroute from the internal server to the public network the server uses the primary link. Does someone know about that behavior?
... View more
Jan 21 2020
6:27 AM
Is by default the configuration NAT Overload in MX appliance? I am working on MX appliance and I can't find the NAT overload in configuration. The LAN use the IP WAN address by to go to internet. In Firewall configuration only have 2 1:1 NAT configuration and 0 1:Many NAT. Thanks.
... View more
© 2024 Cisco Systems, Inc.
