Meraki

rvdtol · ‎Dec 11 2017

Hi MerakiDave, For us the problems are not limited to 220/320 as you described. We experience these problems on350 and 425 switches as well. Also we are not upgrading from a 9.x version but from a 8.x version. Does your proposed mitigation results in rebooting the switches one-by one if configured in a stack? Ps. I already opened a case with Support but they told me that rebooting the switches in 1 stack at the same time is expected behaviour.

rvdtol · ‎Dec 6 2017

Did you even contacted Meraki about this? They told me that it was unexpected behaviour if switches in a stack rebooted at the same time I also asked Meraki support a to send me a report with the exact time of when the switches did reboot (Dasboard is not able to give the precise time). Think of a 'show version' in Cisco classic equipment. Again, they were not able to provide this.....Do you have any tips trick how to obtain this?

rvdtol · ‎Dec 6 2017

Hi all, Last weekend we upgraded our switches (MS425 / MS220) to the 9.32 firmware. Most of our switches are part of switch stacks (with stack modules or flexi stack configuartions) and I noticed that after the firmware upgrade all the switches in a stack rebooted at the same time. I was on the assumption that the switches that are part of a stack never rebooted all at the same time but one-by-one so redundant links from my server clusters and storage would stay up and running. Does some have the same experience? I asked Meraki support and they told me that switches in a stack should reboot one-by-one and never at the same time while doing a firmware upgrade. Looking forward hearing form you!

Meraki

Community

About rvdtol

rvdtol

Community Record

Badges

Re: Reboot switches in stack after firmware upgrade

Re: Reboot switches in stack after firmware upgrade

Reboot switches in stack after firmware upgrade