1. Port Security for All MS Add the possibility to have a Real Port security like we can have in CLI cisco devices. Authorize dynamiclly only 1 MAC adresse by port and flush the table when the device is disconnected. Why ? Because Meraki hasnt got any solution to have a minimal protection for block undesirable device like Dumb Switch Instead of Port Security a new feature who can detect this kind of devices and Block it With port security on CLI with only 1 MAC adresse authorised if a second MAC is detected the port is block and autmaticcly unblock when only one mac adress is detected. It’s not perfect but it permit to limit dumb switch 2. Rules And Authorizations for user on the dashoard Add more possiblity to show/bloc/authorize some functionnality for rules in the dashboard like a complete customizable permissons with groups etc … In some cas we would like to grant access to some user for troubleshoot etc but we can’t block the « reboot » function for example 3. Tool for save and import configuration of a network when we need to transfer the network between 2 template. A lot of configuration are deleted when we switch the template on a network, like VLAN adressing, Wireless pass, DHCP exclusion, Traffic shaping, etc …. We need to reconfigure each time !!!!! A lot of waste time 4. More personnalization on the dashboard Summary of problem for example. (WAN status, devices etc …) possibilty to aknowledge the problem Global personnal view for device to see just what see need to see (moovable block) 5. MX ports Possibilty to disable Port on MX even if they are bind to a template direclty on the dashboard and not on the local configuration page Also ability to configure PPPOE WAN INTERFACE form the dashboard and not froem the local status page Possibility to see what Meraki Device is connected on MX ports. Actually we can just see there is something connected to it. Yes fine ! But what network device ??? ... View more