Hi all,   Got my Meraki switch, AP and Router set up & have been using it for a good year with no issues! Great fun to play with! I have the Router plugged into my ISP (EE) router as a modem.   There was circuit maintenance the other day & since, I've had to manually configure DNS servers on the endpoints to 1.1.1.1/1.0.0.1 for them to work, otherwise, it fails to find DNS. can ping IPs but not domain names.   The router is configured to point to the EE router for DNS. The Switch and AP are pointing to the Meraki router, but are both reporting "DNS is Misconfigured" error.    Have turned the WiFi back on the EE router for testing & devices connected directly to the EE WiFi can find DNS with no configuration required.   I have also tried putting the EE Router in as Primary DNS for the Meraki Switch & AP, but still, no luck getting it to work.   Any ideas you lovely people?   TIA! ... View more

Hi all,   I have a Chromecast Gen 2, which I have connected to my SSID with no splash page or anything (meraki default). My phone is also connected to this same SSID. It connects fine but in the initial setup, I get the error below (pic attached). Isolation is not enabled. I read that creating a policy to bypass splash page could be a solution (regardless of whether or not a splash page is being used), which had no effect, even though I added the Chromecast to the clients list by MAC. As far as I'm aware, the Chromecast is connected as is my phone, however, neither can communicate over the network. Again isolation is NOT enabled. The Chromecast shows up on the clients list but when I click on it, I get the message: "Sorry, we couldn't find that client. Please go back and try again"   I'm at my wit's end with this. Any help would be GREATLY appreciated!   TIA!!   ... View more