Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About JoshRans
JoshRans
Here to help
Member since Oct 30, 2019
Oct 31 2019
Community Record
7
Posts
0
Kudos
1
Solution
Badges
Oct 31 2019
3:19 AM
Case solved, thanks all. The 3rd party provider finally changed us to a /29 after advising this is the only solution. My cores are now on this range with the router as the gateway.
... View more
Oct 30 2019
4:43 PM
Hi @DarrenOC and thanks guys. Yes my core switches are on the management range but the firewall is on the /30 internet break out range. I have also done plenty of Meraki installs but the firewall is normally on the management range with the switches. Regards, josh
... View more
Oct 30 2019
3:05 PM
@cmr I have 5 interfaces on the core stack as shown in my gyazo screen capture, I am wondering what IP address and gateway should be applied to each of my 2 core switches. Thank you Josh
... View more
Oct 30 2019
1:56 PM
@Nash That is my problem, we do not manage the ASA and they will not make it a /29 to give us a few more addresses. It seems like they cannot give me a /29 because it will conflict with their other services. I have however requested a new /29 range from them, hopefully this can be done as it seems like the only solution. Thanks very much!
... View more
Oct 30 2019
1:32 PM
@Nash Thank you Nash. For this case, I have 2 core switches and only 2 available hosts are provided on the /30. Therefore I cannot IP both switches on this range along with the router and vlan interface IP. Unfortunately the 3rd party provider will not give us more IP addresses.
... View more
Oct 30 2019
12:45 PM
Thank you Phillip. I will continue further in the morning. Here is my current Routing & DHCP setup https://gyazo.com/e0b18684d39f9b11e646243c357c5b5b Just to confirm, which IP address range should the core switches be on please? Sorry, it is just the first situation where my next hop has been on another range to the core devices. Regards, Josh
... View more
Oct 30 2019
12:15 PM
Hi all, Hopefully I can find a solution or confirmation on here 🙂 I have recently installed X2 Stacked Cisco Meraki MS-425-16 Core Switches with 30 Edge Switches. The switches are on a 'management' VLAN range and I have a 3rd party ASA router that needs to be on a /30 'internet breakout' range. What should the cores gateway be? I am unable to set the ASA as the default gateway on the core switches as they are on a different range. I normally point my edge switches to the core stack as the gateway and use the router as the gateway on the core's as they're normally on the same range. I tried to add my core switches to another range where I have a smoothwall webfilter, added the smoothwall as the gateway which then points back to the core stack as its gateway but this also did not work. Connecting a 4g router on the same management range and setting this as the default gateway for the cores works but this is not ideal. Any help or advise would be much appreciated. Josh
... View more
My Accepted Solutions
| Subject | Views | Posted |
|---|---|---|
| 7749 | Oct 31 2019 3:19 AM |
© 2024 Cisco Systems, Inc.
