Meraki

Community

About Moorera

Re: Starlink Stats Page

by in Security & SD-WAN
‎May 8 2022 8:48 AM
‎May 8 2022 8:48 AM
Hey I like that idea.  I've ordered a micro usb RJ45 ethernet adapter.  When I get that I'll have a look and see what I can do.  Only wish this was more a API than a l web page...  ... View more

Re: Starlink Stats Page

by in Security & SD-WAN
‎May 8 2022 4:54 AM
‎May 8 2022 4:54 AM
That lack of outbound NAT I think is the challenge.  I'm going to stick with this setup and start a nano-pi-w and see if I can plug in a Mirco Usb LAN interface (gotta find one first) and use that to act as a VNC accessbile bridge like device.  I can connect to the Pi via WiFi and access the stats page from it via the Micro USB Ethernet link. I know I have some connectivity problems and really want the stats to help troubleshoot. ... View more

Re: Starlink Stats Page

by in Security & SD-WAN
‎May 7 2022 11:42 AM
‎May 7 2022 11:42 AM
Thanks... This solution still have challenges.  If I have a device on that VLAN then I can read the stats page. If I am on another VLAN I cannot. It looks like that DISHY must have some ARP issues as it can never return the packet to a off VLAN device as it never finds a gateway. ... View more

Re: Starlink Stats Page

by in Security & SD-WAN
‎May 7 2022 6:31 AM
‎May 7 2022 6:31 AM
Thanks this was what I was thinking but couldn't bring myself to build this. Guess I have to now as I cannot think of anything else.  🙂   ... View more

Starlink Stats Page

by in Security & SD-WAN
‎May 7 2022 3:09 AM
‎May 7 2022 3:09 AM
Has anyone managed to access Starlink Stats from the LAN side of their MX?  I can see packets leave the MX but never return when I use the capture capability on the MX for this.  I suspect the Firewall is dropping had a ticket open with Meraki but then got busy at work and wasn't able to follow up.  Though in the back and forth I did have going on with them before getting busy the thought was the MX is delivering the packet out its WAN interface following the 0.0.0.0 route and it should not be Meraki.  If I look at other routers they always have to define a static route to 192.168.100.0/24 out their WAN interface to make this work (Which I guess adjust's their Firewall rules for inbound).   I believe I need to build an inbound rule and static route but that doesn't seem possible as static routes are only for LAN interfaces and you cannot create an inbound for IPv4.   Thoughts? Regards ... View more
© 2024 Cisco Systems, Inc.