Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Jaakkot
Jaakkot
Comes here often
Member since Sep 20, 2019
Oct 28 2023
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
Oct 16 2023
12:04 PM
Indeed. Just a thought, do you think it could help with the DHCP issue if I would add a MX device between the switch and Gateway?
... View more
Oct 16 2023
11:43 AM
Yes, native vlan is 1 correct, the settings are identical to the port where I have functioning AP. DHCP and Network Gateway are provided by the Service Provider, which I don't have direct access to. Makes it more tricky.
... View more
Oct 16 2023
10:20 AM
Absolutely: Port status Enabled Type Trunk Native VLAN1 Allowed VLANs all Access policy Open Link negotiation Auto negotiate (1 Gbps) RSTP Enabled (Forwarding) Port schedule Unscheduled Port isolation Disabled Trusted DAI Disabled UDLD Alert only Tags none PoE Enabled Port mirroring Not mirroring traffic I can see that there is minimal traffic going all the time.
... View more
Oct 16 2023
10:08 AM
I was thinking the same, but after plugging in an videoconferencing endpoint directly to the switch, the endpoint did not receive IP either. For an unknown reason it seems that the switch is only giving give IP address to the AP that is currently working.
... View more
Oct 16 2023
9:37 AM
No unfortunately, it did not. Might be worth mentioning that when I enable meshing from network wide - general, the AP starts working as a repeater.
... View more
Oct 16 2023
9:29 AM
Hello and thank you for your reply. No, there are no firewalls. I did factory reset the AP as well.
... View more
Oct 16 2023
9:04 AM
My first post here, hello Meraki community! As I can't find a solution to my Meraki issue, first time after so many years of use. About my set up: I have a set up of one Meraki Switch (MS120-8-LP) and two access points (MR33). The switch and one AP is working fine, but for some reason the other AP is unable to connect to cloud and come online. I've gone through Meraki troubleshooting guide and tried different cables, different ports, with PoE and with injector. I've even tried connecting the problematic access to the same port, with the same cable that the functioning has been using, but it's still unable to come online. When looking at the ports of my switch in the dashboard, it does recognize that the access point is there (including MAC address in CDP/LLDP) and it's using PoE, but when clicking to the access point, it's unreachable. I have ran out of ideas of what to try next. I thought that the AP could be broken, but then I tested plugging in an endpoint and it could not come online either, so the issue might not be access point. Same story here, in CDP/LLDP section I can see the MAC-address of the device. If you have any tips of what I could try to do solve this please let me now. I've gone through the forum a lot and tried bunch of stuff, but nothing has yet been a hit. Big thank you in advance!
... View more
© 2024 Cisco Systems, Inc.
