Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Srikanth
Srikanth
Here to help
Member since Sep 3, 2019
Sep 13 2021
Community Record
8
Posts
2
Kudos
0
Solutions
Badges
Sep 6 2021
11:47 PM
@PhilipDAth we have checked the security groups and they aren't blocking any traffic , the packet was being received by vMX and then there were update messages which was sent by Palo Alto to the vMX. after multiple update messages which were received on the vMX end there was a reset message sent from vMX
... View more
Sep 6 2021
11:43 PM
@PhilipDAth we have done a packet capture and which states that the Keep alive packet are being sent by Palo Alto to the vMX, but vMX doesn't respond back with a keep alive packet
... View more
Sep 6 2021
9:34 AM
@ww @PhilipDAth @Bruce Could you please provide a solution on the above issue
... View more
Sep 6 2021
8:46 AM
@ww on the vMX our version is : MX 15.42.2
... View more
Sep 6 2021
8:26 AM
@ww the version which we are using is Palo Alto version 9.1
... View more
Sep 6 2021
7:48 AM
Dear Team, we have established BGP between vMX and Palo Alto in Azure using EBGP, we were successful to establish the connectivity but the BGP keeps on flapping upon the Maximum Hold Timer expires. ex: the BGP flaps every 240 seconds as the EBGP hold timer is set at 240 seconds. Please share your valuable feedback on how could we resolve this. Thanks, Srikanth
... View more
Jun 11 2021
11:23 AM
@BrandonS Thank You for your quick revert, in the diagram shown there the VNET peeing is configured between the primary and secondary hub but is this possible if we install multiple vMX in the same primary hub and how can we establish communication between the vMX and load balance the traffic
... View more
Jun 11 2021
11:09 AM
2 Kudos
With the limitation of Meraki virtual instance vMX on Azure, and Azure only supporting vMX medium, Could you please help on how can we install 2 SKU of Meraki vmx on Azure in Active-Active state to load balance traffic from spokes in multiple regions this is mainly to utilize the Meraki Auto VPN feature between hub and sites. Please share your thoughts or experiences on how this can be enabled. Thanks, Srikanth
... View more
My Top Kudoed Posts
| Subject | Kudos | Views |
|---|---|---|
| 2 | 1756 |
© 2024 Cisco Systems, Inc.
