Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About S_Burke
S_Burke
Comes here often
Member since Aug 27, 2019
Dec 6 2019
Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Aug 28 2019
9:12 AM
@BrechtSchamp Still losing everything.
... View more
Aug 28 2019
7:02 AM
From the Meraki dashboard.
... View more
Aug 28 2019
6:28 AM
@BrechtSchamp Here's the first appearance of the target IP (10.24.0.141) which is one of the printers. 13:18:27.641872 ARP, Request who-has 10.25.0.1 tell 10.25.0.141, length 46 13:18:27.642745 ARP, Reply 10.25.0.1 is-at e0:cb:bc:77:b3:18, length 46 10.25.0.1 is our gateway. There are no echos in the packet capture.
... View more
Aug 28 2019
6:12 AM
@BlakeRichardson Sure. Each of the MS225s has MR42s attached to it. Some of them also connect to wall plates. The MS225 in the red zone, which is the addition, has both wall plates and MR42s attached to it.
... View more
Aug 27 2019
12:26 PM
All of our other printers are pingable. The pinging isn't really the problem, the problem is that I can't connect anyone's devices to to the printers to add them as network printers. The pinging was just part of my trying to figure out what was wrong.
... View more
Aug 27 2019
12:22 PM
I'm trying to ping from the Meraki switch that the devices are wired to. We currently have VLANs set up by building for the most part, as opposed to by device category or anything like that.
... View more
Aug 27 2019
12:20 PM
I have tried from the new addition and the old site. Subnet is the same. We have the same SSIDs broadcast in all three buildings for the most part outside of some that are restricted to a specific AP. I can't ping the printers from anywhere - I have tried in that building and out, and I have tried with my computer connected to the same SSID that I have assigned to wired clients.
... View more
Aug 27 2019
10:32 AM
Hello all, I have two printers misbehaving in a new addition to our campus. The new addition has its own switch and the printers (both Lexmark M3150) are connected via wall jacks. In the Meraki dashboard, the printers show up as connected and have IP addresses that are the same as what is displayed on the screen of the printers. However, I can't ping them from the Meraki dashboard - it times out every time. I also can't traceroute or ping from my laptop. Thoughts?
... View more
© 2024 Cisco Systems, Inc.
