Meraki

BrianSTL · ‎Feb 28 2020

It took me a minute but I understand what you are saying.. I think what I need to do is reserve IPs in the Wireless allocation so I can route to that specific IP. .So when a Cradlepoint pulls in the garage I need to have a reservation or possibly even a different SSID on another subnet that will handle routing for all or 192.168.0.xxx/24 subnets. It will assign that "reserved" address to the CradlePoint and that becomes my next hop. My brain hurts trying to figure out how a PC can be behind a router that moves networks on the WAN side and the MX handle routing to the same address space depending on what is connected.

BrianSTL · ‎Feb 28 2020

I have a fleet of vehicles that use CradlePoint devices to terminate Non-Meraki Peers while on LTE in the field. It works wonderfully. Now the trucks need to pull into our garage where they will pull up wireless on our local network. In the field our trucks use 192.168.1-25.0/24. I was going to use the feature "Active When Next Hop Responds to Ping" on a static route. This seemed logical as when the truck pulls into the garage the 192.168.1.2 Gateway will be available on the CradlePoint side. However, I am required to setup all these subnets and when I do I get a conflict that the subnet already exists in the Non-Meraki Peers and the config can't be saved. Am I approaching this incorrectly? As it doesn't seem possible.

Meraki

Community

About BrianSTL

BrianSTL

Community Record

Badges

Re: Non-Meraki Peers + Subnet Routing

Non-Meraki Peers + Subnet Routing